Mounting Hardware is Included
This is a press fit mount. Utilization of a sight pusher tool may be required.
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
This mount fits:
- Ruger MK I (Ruger Mark I)
- Ruger MK II (Ruger Mark II)
- Ruger MK III (Ruger Mark III)
- Ruger MK IV (Ruger Mark IV)
- Ruger P85
- Ruger P90-95
- Ruger P97
- Ruger 22/45
This mount doesn’t fit:
- Ruger P89
Material: 7075 AluminumCoating: Matte Black HardcoatOverall Length: 1.811″Overall Width: .99″Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (2) 6-32 Set Screw
Red Dot Fitment:
- Viridian RFX25
- Vortex Viper
- Vortex Venom ( Not Enclosed )
- Burris FastFire
- Burris FastFire 2
- Burris FastFire 3
- Burris FastFire 4
- Docter
- ADE RD3-001
- ADE RD3-002
- ADE RD3-009
- UTG Reflex Micro Dot
- Crimson Trace CTS-1200
- Crimson Trace CTS-1300
- Sightmark Mini Shot
- Cuda RX-795
Red Dot Fitment:
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.Installation Instructions– Remove the rear sight*- Install the EGW Sight Mount in the dovetail- Tighten set screw (if applicable)- Place the red dot sight on the EGW Sight Mount(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)- Apply blue Loctite to the provided mounting screws- Torque mounting screws to 15in/lbs2 Button Head Cap Screws – Provided for Vortex Viper and Venom Sights2 Flat Head Cap Screws – Provided for Burris FastFire and Docter SightsThe screws that are included with this mount require a 5/64” allen wrench for installation.
